Hello,
Sorry for my not speaking Deutsch ...
I am trying to troubleshoot a Bebop2 motherboard.
After typing the following Telnet command :
BLDC_Test_Bench_S
the 4 (four) motors (without the blades, of course) will all start spinning, then abruptly stop after 3 seconds.
Then, after checking the failure reason ( with BLDC_Test_Bench_I ), I receive the following message :
Version is: '5.1.R.4'
Previous flight time : 3 seconds
Laste error : 'Communication with motor failed by timeout'
Any clue ?
Thanks !
Sorry for my not speaking Deutsch ...
I am trying to troubleshoot a Bebop2 motherboard.
After typing the following Telnet command :
BLDC_Test_Bench_S
the 4 (four) motors (without the blades, of course) will all start spinning, then abruptly stop after 3 seconds.
Then, after checking the failure reason ( with BLDC_Test_Bench_I ), I receive the following message :
Version is: '5.1.R.4'
Previous flight time : 3 seconds
Laste error : 'Communication with motor failed by timeout'
Any clue ?
Thanks !
Dieser Beitrag wurde bereits 1 mal editiert, zuletzt von DroneFuchs ()