Hello there,
pleas help i stuck at a problem for Days.... When i Arm my Copter or testing the motors on betafilght the dji air unit o3 shut down and the motors stop. It is connected with the normal calbe between airunit and fc.
The test for motor spinning works but when i start a test with more than 1040 rotaions in betaflight the dji air unit stops working too. Looks like a Volatgeproblem. All oins on the Fc has the correct voltage before i arm it. After the Dji O3 shut down, all volatge ports has 3,3 volt ( 3,3, 5 and 9 V slot). All Cabels are connected correctly and no touch with the frame. Also the whole ariunit is with silicon isolated to the frame. The Fc has still Power after the airunit is shutting down.
set up : Speedybee f 405 v3 , T-Motor v2207 v2 1950 kv , Airunit 3 ,DJI Remot 2, Dji Google V2
PS: before i arm, the OSD and is showed right in the Googles and the voltage of the batterie too. After arming the connection is lost.
please please help....
pleas help i stuck at a problem for Days.... When i Arm my Copter or testing the motors on betafilght the dji air unit o3 shut down and the motors stop. It is connected with the normal calbe between airunit and fc.
The test for motor spinning works but when i start a test with more than 1040 rotaions in betaflight the dji air unit stops working too. Looks like a Volatgeproblem. All oins on the Fc has the correct voltage before i arm it. After the Dji O3 shut down, all volatge ports has 3,3 volt ( 3,3, 5 and 9 V slot). All Cabels are connected correctly and no touch with the frame. Also the whole ariunit is with silicon isolated to the frame. The Fc has still Power after the airunit is shutting down.
set up : Speedybee f 405 v3 , T-Motor v2207 v2 1950 kv , Airunit 3 ,DJI Remot 2, Dji Google V2
PS: before i arm, the OSD and is showed right in the Googles and the voltage of the batterie too. After arming the connection is lost.
please please help....